Introduction to knowledge related to softening water equipment
Views : 11
Update time : 2025-06-04 17:42:36
Softening water equipment can be widely used in the softening of feed water for steam boilers, hot water boilers, exchangers, evaporative condensers, air conditioners, direct-fired engines and other systems. It can also be used for the treatment of domestic water in hotels, restaurants, office buildings, apartments, etc. and softening water in food, beverages, brewing, laundry, printing and dyeing, chemicals, medicine and other industries. It has been widely used in the circulating feed water of various steam boilers, hot water boilers, heat exchangers, steam condensers, air conditioners, direct-fired engines and other equipment and systems. In addition, it is also used for domestic water treatment, food, electroplating, medicine, chemicals, printing and dyeing, textiles, electronics and other industrial water treatment and as a pre-treatment for desalination systems.
Application and maintenance of softening water equipment: 1.The quality of raw water should meet the requirements of general sodium ion exchange water treatment equipment. 2.The equipment is installed indoors. To prevent the resin from freezing and parts from rusting, and electrical short circuit failures, the ambient temperature should be above zero degrees, and there should be no steam, and it should be relatively dry and clean. 3.After the equipment is in place, all fixing bolts should be tightened again, and the switchboard housing should be grounded; the upper and lower bolts of the lever fixing block on the rotary valve should not be loose, and the exchange column should not be hit. 4.The time relay should not be adjusted during operation, and the power supply should be cut off when repairing and scrubbing the equipment, and the motor, switchboard, and limit switch should be prevented from entering the water. 5.During operation, water and electricity should be supplied at the same time, and when it is shut down, water and electricity should also be turned off; 6.Always keep the equipment clean, the refueling part should not be short of oil, and be careful not to touch the pulley during operation to avoid accidents.
Nowadays, a fully automatic softening water equipment has appeared on the market. The equipment is controlled by an advanced program device, operates accurately and reliably, replaces manual operation, and fully realizes the automatic conversion of all links of water treatment. High efficiency, low energy consumption, and economical operating costs. Due to the reasonable overall design of the softener, the exchange capacity of the resin can be fully utilized. The equipment adopts jet salt absorption to replace the salt pump, which reduces energy consumption.
